FastTEMP Kit

(Voltage Outputs)

MPN: fastTEMP Category:

ECM’s FastTemp™ thermocouple module outputs ultra-high bandwidth temperature measurements using standard K-Type (Chromel Alumel) grounded thermocouple probes.  Measurements that once required a 0.005″ (0.13mm) diameter exposed-bead thermocouple can now be performed using a 1/16″ (1.5mm) shielded (i.e.  more rugged) thermocouple.  The speed increase is made possible by ECM’s proprietary active-drive thermocouple circuitry.  With FastTemp™, fast dynamic temperature information hidden by conventional thermocouple amplifiers now becomes available for use.  FastTemp™ is especially suited for temperature measurements in the exhaust of engines for engine control, engine durability, turbocharger, aftertreatment, and exhaust system development.

Response Time Fast Output: Less than 50 ms (10 to 90%)
Standard Output: Dependent on probe used
Power 6 to 35 VDC, 200mW typical
500V galvanic isolation from sensor input and outputs
LED power status indicator
Dimensions 152mm x 70mm x 30mm (6" x 2.75" x 1.2"), 360gm (12.7oz)
Two 1/5" (5mm) holes from top, Two 10-32 (M5 x 0.8) threaded holes on back
Sensor Cable 2m, Power Cable 2m.
Operating Temperature For module (electronics): -55 to +125°C, 100% humidity, environmentally sealed, IP67
Ranges & Accuracies
Temperature -60 to 1370°C (-76 to 2498°F)
± 1°C RTI (relative to input)
± 10mV RTO (relative to output)
Internal cold junction compensation
Analog 5mV/ °C for Fast and Standard signals
Less than 500Ω output impedance
200V Isolation from sensor input to outputs
2 Female BNC connectors

Included Kit Components

Filters Sort results


Note: To connect multiple FastTemp modules, you will need P/N 09-04, 09-05, and FT-11 per module.




FastTEMP Manual (Ver. 2020-07-23, 202 KB)
FastTEMP Technical Notes (Ver. 2010-03-08, 89 KB)
FastTEMP Diagram (Ver. 2012-03-28, 368 KB)
FastTemp Brochure (Ver. 4-15-2014, 121 KB)